Please read ALL directions before starting installation.
Installation conditions:
Install only on clean, dry concrete at temperatures above 40ºF (5ºC).
Remove existing weatherstripping from door bottom.
For best adhesion, rough up concrete surface with wire brush before applying glue.
Not recommended for installation on asphalt, painted or treated surfaces, broken
concrete or gravel.
Tools:
Tape measure
utility knife
pencil
|
Instructions:
1. With garage door open, center threshold between the garage door track (the
channel the door rollers ride in). Trim to length with utility knife. (The "hump" side
should on the inside side of the door.) |
| 2. Lower the garage door on top of the threshold's
2-inch level strip. Push the 45º hump against the
back of the bottom of the garage door. Note: Notch
threshold around door jambs, if necessary, to
ensure the 45º hump is against the back of the
bottom of the garage door. |
 |
| 3. With the pencil, mark the inside edge of the
threshold on the floor the full length of the
threshold (from one door jamb to the other). |
 |
| 4. Carefully raise the door (without moving the threshold) and mark the outside edge of
the threshold the length of the door. Rough up the area between the marks with a wire brush for best adhesion. |
| 5. Remove the threshold and apply three rows of
adhesive the full length of the door between the
pencil lines as shown. |
 |
| 6. Replace the threshold between the pencil lines
and firmly press into place. Carefully apply
pressure to the threshold to ensure the adhesive
spreads uniformly. |
 |
| 7. Inspect the threshold to make sure it is still between the pencil lines. The position
can be slightly adjusted for a short period of time. The length of time varies depending on
ambient conditions. |
 |
| 8. Close the garage door to keep constant pressure
on the threshold for twenty-four (24) hours. |
 |
| ALLOW AT LEAST 24 HOURS FOR ADHESIVE TO DRY BEFORE DRIVING OVER. |
| |
|
